[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: z80 boards
Chuck,
I built 2 cards and they both worked perfect with the CFFA3000. My question is what "CP/M image" did you use? FYI, MS SoftCard disks will not boot this type of card.
Rick
On Tuesday, May 14, 2013 1:20:53 PM UTC-5, Chuck Morris wrote:
> I finally got around to assembling my card and made an initial (unsuccessful) attempt to verify that it works. I've installed it in slot 3 of my IIe, which has a CFFA3000 in slot 7, uses slot 6 as a virtual Disk II, with a DuoDisk in slot 5. No blue smoke appeared on power up, which is good as far as it goes. I've tried booting up with a CP/M image from a USB key assigned to a virtual Disk II drive, with no luck. I'm not sure if the settings I'm using on my CFFA3000 might be part of the problem or not, so I'll experiment with changing those when I get a chance.
>
>
>
> Has anyone else used one of these cards with specifically the CFFA3000 card before? If so, did you experience any issues?
>
>
>
> Thanks,
>
> Chuck