Re: Saturn 128k Problems

[Hugh Hood <hughhood@earthlink.net>]

Steve:

I booted up RoboCAD on my IIe this morning and tested:

A. Ctrl-Reset -> RoboCAD 'traps' the reset key and presents a message about
'Press Return to Continue'

This keeps you from losing your drawing and keeps (most) folks out of the
monitor for disassembly

B. OA-Ctrl-Reset -> the machine reboots


This is in a machine with a Transwarp (with the Saturn card selection), so
throw that variable into my test results.





Hugh Hood





in article L9Gdnb017NT4lFHSnZ2dnUVZ_rWdnZ2d@giganews.com, Steven Hirsch at
snhirsch@gmail.com wrote on 6/3/12 8:03 PM:
> 
> Are you able to interrupt (Ctrl-Reset) or reboot (OA-Ctrl-Reset) the machine
> when RoboCAD is active?  Neither works for me.  It just freezes up with one of
> the LEDs on the Saturn card lit.
> 
>