On 06/04/2012 10:49 AM, Hugh Hood wrote:
Steve: I booted up RoboCAD on my IIe this morning and tested: A. Ctrl-Reset -> RoboCAD 'traps' the reset key and presents a message about 'Press Return to Continue' This keeps you from losing your drawing and keeps (most) folks out of the monitor for disassembly B. OA-Ctrl-Reset -> the machine reboots This is in a machine with a Transwarp (with the Saturn card selection), so throw that variable into my test results.
I cannot reproduce that, leading me to believe that I do have a problem with the Saturn board. I'm going to try swapping out some of the LS TTL logic for newer parts and see if I can get it to behave.
Would still be great if someone had the schematic.