Re: HELP!! Needed /transwarp & IIGS??

[Wayne Stewart <waynes@intergate.ca>]

Barry Allen wrote:

> I'd say yank the Transwarp and make sure the fingers (contacts) are clean
> on the card, replace and make sure the card seats firmly. The most likely
> problem is that the Control Panel needs to set to "YOUR CARD" whatever slot
> the Transwarp is in. With no battery, it changed back to the default
> setting of whatever slot the Transwarp is in and the GS doesn't see the
> card.
>
> And there is no software, the control panel installs itself when you insert
> the card. Also make sure the CPU replacement chip is seated correctly as
> well.

It won't be dirty fingers or your slot setting since the TranswarpGS will
function just fine even if it's not in a slot and just lying on top of the
motherboard. A dead battery won't cause you to lose your TranswarpGS
control panel but could the battery have been installed backwards? I have
no idea what reversing the batteries polarity would do and don't really
want to try that experiment with a TWGS. Did you remove the TWGS
when changing the battery? If so, did you unplug the TWGS ribbon cable
from the card or from the computer?

    Wayne