Re: RamFAST questions

[Wayne Stewart <waynes@intergate.bc.ca>]

william strutts wrote:

> I now have my HD working using my RamFAST card but
> I can't figure out how to access my floppy drives with the
> HD attached.  I have the RamFAST mapping two partitions
> to Slot 7 in the Drive 1 and Drive 2 positions and I left
> the rest alone.  I can remap the drives in the utilities so
> that my ProDOS partition can boot instead of my GS/OS
> partition.  However, it gives me invalid drive when I try
> to use CATALOG S6,D1 or CAT S5,D1.  I have found
> that in the RamFAST utility I can boot from a floppy but
> why can't I see the floppies when I boot from the HD?
> I can also see all of my partitions if I use the /volname
> in the CAT command instead of the Slot number.  I can't
> seem to use the Sx,Dx parameter at all with the RamFAST
> card installed.

I'm using a Rev D with the 3.01-F  EPROM in slot 7. I have
slot 6 set to disk port and if slot 5 is set to smart port I can access
my floppy drives in a normal manner.
In basic CATALOG S6,D1 or CAT S5,D1 give me a "PATH
NOT FOUND" but CATALOG,S6,D1 or CAT,S5,D1 seem to
work normally with the ramfast installed.

    Wayne