Re: Zlink Block Error Problems.

[Rubywand <rubywand@swbell.net>]

Ernest writes ...
> 
> The good news is that I'm able to send characters back and forth, between my
> apple IIe and my WinPC, using 7n1, instead of 8n1, at 19200.
> 

     Sounds like you're getting very close to success.



> The problem that I'm having, in trying to transfer a test file (adt.asm) is
> that, after setting Zlink to:
> 
> VT100
> Capture buffer Off (tried with CB on also)
> 19200 baud
> 7n1
> slot 2
> Save file to Zsaves (disk 2)
> File receiving - ADT.ASM (as a test)
> SuperSerial Card settings are: OFF,OFF,OFF,OFF,ON,ON,ON /
> ON,OFF,OFF,ON,ON,ON,OFF
> 
> which matches the settings that I have set on HyperTerminal (PC side) except
> for AutoDetect as emulation, when I try to have Zlink receive the file, I'm
> getting  10 Block Number Error messages, and then it tells me that the
> Transfer Aborted By Sender.
> 
> I've tried that same settings, except at 9600 baud, with the same results.
 ....

     Try going back to 8-N-1 and selecting no emulation for ZLink. You do not mention the protocol you are using. For ZLink with Hyperterm, use Xmodem. Also remember to always start the ZLink side first for any file transfer.




Rubywand