Zlink Block Error Problems.

["Ernest" <ernestls@home.com>]

The good news is that I'm able to send characters back and forth, between my
apple IIe and my WinPC, using 7n1, instead of 8n1, at 19200.

The problem that I'm having, in trying to transfer a test file (adt.asm) is
that, after setting Zlink to:

VT100
Capture buffer Off (tried with CB on also)
19200 baud
7n1
slot 2
Save file to Zsaves (disk 2)
File receiving - ADT.ASM (as a test)
SuperSerial Card settings are: OFF,OFF,OFF,OFF,ON,ON,ON /
ON,OFF,OFF,ON,ON,ON,OFF

which matches the settings that I have set on HyperTerminal (PC side) except
for AutoDetect as emulation, when I try to have Zlink receive the file, I'm
getting  10 Block Number Error messages, and then it tells me that the
Transfer Aborted By Sender.

I've tried that same settings, except at 9600 baud, with the same results.

Can anyone tell me what I'm doing wrong?