Moving a Focus drive external: termination?

[Kris Jones <razor@speakeasy.org>]

I consider myself fairly SCSI literate, although termination still messes with
me.

If I was to pull the 2.5" Conner off of the Focus board and connect a 2.5" IDC
to 50pin IDC ribbon cable, and then put the cable into a socket with a 25pin
external apple cludge, I could run SCSI externally, right?

Or is this card hardwired for only one device, specifically the Conner drive?

If not, I figure, by most standard conventions, the board itself would have
termination, and then the drive would be terminated, correct?

Or would I need to terminate at the beginning and the end of the SCSI chain?

Basically, 
1. is the Focus board a standard scsi controller? Can it support 7 devices?
2. is their termination on the board, or would I need to put all the termination
on the chain itself, externally?

Thanks for any input
-Kris