Re: Dancing windows

[Rubywand <rubywand@swbell.net>]

ladyphoenixxii@my-deja.com writes ...
>>
It all started when I added a Focus 500 meg to the Ramfast with a ZIP
drive on a ROM 3.  I switched the Ramfast to an Apple High Speed SCSI
reinstalled the system 6.0.1, Spectrum and added Prosel to fix.
<<
 ....
> supertimer@aol.com (Supertimer) wrote:
 ....

> Thanks for the info on the SCSI driver.  The problem
> showed up with the Ramfast/driver. I removed the 6.0.1 generic driver.
> I did put floppies in the 3.5" drives which helped.  But when I open
> volumes the dancing is so bad I can't select and open anything not
> in the window.  Will write Wing Cheung about the Tulin driver.  Sandy
 ....

     If you have always been running with the Sys 6.0.1 SCSI drivers
installed, you might try going back to the RamFAST and RAMfast driver. Only,
this time, remove all of the Apple SCSI drivers and the SCSI Manager-- this
should get rid of driver conflicts. If you do not use AppleTalk, you can
probably dump the SCC Manager, too.

     Put your Focus in Slot 7 and your RamFAST in Slot 2. In the Control
Panel, set both Slots to "Your Card".



Rubywand