InnerDriver owners: Info needed

[dmasters@freenet.columbus.oh.us (Dan Masterson)]

 Recently I obtained an InnerDrive power supply with a 40mb hard drive
that was removed and used in another HD case.  They desolderd the
connections from the hard drive to the power supply board (at the hard
drive circuit board).  What I need to know is the order the wires are
connected to the solder pads and which white wires go in which
location.  I want to just splice a 4 pin connector to the power supply
wires and just plug it into the hard drive instead of trying to
resolder the wires.

Below is a rough drawing of what the whole thing looks like.

	FRONT OF POWER
	SUPPLY CASE AND
	HARD DRIVE LOCATION
	 _______________
	|               |
	|               |
	|               |
    ====|               |         
	| solder pads   |
	| ....          |  <-- WHERE WIRES WERE ORIGINALLY SOLDERED.    
	|               |
	| ____          |
	| oooo          |  <-- LOOKING AT THE END OF THE HARD DRIVE.
	|_______________|      THIS IS THE CONNECTOR.
	|               |
      __|               |
     |    **+**+        |  <-- * = WIRES ON THE POWER SUPPLY CONNECTOR.
     |                  |      + = AN EMPTY HOLE IN THE CONNECTOR.
     |                  |      WIRE COLORS ARE FROM LEFT TO RIGHT.
     |                  |      YELLOW, ORANGE, WHITE AND WHITE
     |                  |
     |__________________|

	BACK OF POWER
	SUPPLY CASE       
-- 
=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=
|||                Sudden Impact Kustomz  Columbus, Ohio                |||
=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=