Re: How to transfer files from ][GS to PC

[spec@vax2.concordia.ca (Mitchell Spector)]

In article clemw@aol.com (ClemW) writes...

>After conecting the Apple and the PC via serial cable,
>what software do you run?  Do you run procomm on the PC?
>What do you run on the Apple?  -Clem

    Any terminal software will do, on the PC side I often use either
HyperTerminal, Procomm Plus or Terminate. On the Apple side I mostly
use ProTERM, although Spectrum is essential if your moving data to
or from HFS partitions. 

    Just make sure the setting on both ends match (i.e. 8 bits, no
parity and 1 stop bit, and most importantly, the baud rate). Using
an Apple IIgs will allow you to set both sides to 57600 bps. Then
just send files using Zmodem.

Mitchell Spector
spec@vax2.concordia.ca