Re: ImageWriter II Loop Back Failure

["Tom Zuchowski" <tjz@mindspring.com>]

"Loop Back Test Fails"?  Doesn't that test require a loopback connector?

I don't know anything about IW's but I do work with computers and every
loopback test I ever saw required a special loopback connector so the test
could check out its own port.

TomZ


Bill Shuff <bill2060@cris.com> wrote in article <3269D425.17C0@cris.com>...
> J. L. Walters wrote:
> > 
> > He gets the following printout on the printer:
> > 
> > ROM Rev  (01)
> > Dip Sw 1 (00000100)
> > Dip Sw 2 (1100) /1 = on, 0 = off/
> > About 4 blank lines followed by:
> > Loop Back Test Fails
> > 
> > At this point the error light goes on the IW II.
> > 
> > Any idea how he should proceed?
> >