CV Tech Piggy-Back RAM

[steve.townsend@rook.wa.com (Steve Townsend)]

Configurations!
    
    I have a CV Technologies "Piggy-Back" Memory Card.
(Rev.B) with 4-Meg installed in my IIgs.  Until recently
I also had a 1-Meg RAM card installed in the piggy-back slot,
but I pulled it out because I needed it in another machine.
    As a consequence, I need to know how to reconfigure the
jumper blocks so that programs that check that sort of thing
(like AppleWorks 3.O) upon booting know that there is only 4-Meg
of RAM installed and doesn't go looking for the Fifth Meg.
    
    It looks like this now:
    
              ______________
             |     A  B  C  |
             |  1  .  .__.  |    (Configured for 5-Meg)
             |  2  .  .__.  |
             |______________|
    
    
    The question again, is how do I configure these jumper
blocks to run with 4-Meg installed on the CV RAM card when the
piggy-back slot is empty?    
    Here is a blank.  Fill it in and send it back to me if
you know this answer.
         
    
              ______________
             |     A  B  C  |
             |  1  .  .  .  |    (Please Configure for 4-Meg)
             |  2  .  .  .  |    (with Piggy-Back Slot Empty)
             |______________|
    
    
                         Thanks!,
                                          
                         Steve.Townsend@rook.wa.com       or
        
                         townsend@potlatch.esd112.wednet.edu
        
PS
    If you should so happen to know what ALL 10 of the possible
configurations represent I would also like that have that for future 
reference. 
    
PPS
    What would happen if I put a 2-Meg or 4-Meg card into the 
piggy-back slot?  Would I get 6-Meg or 8-Meg or RAM?  or would I 
do some damage?
    
                         Thanks Again,
    
                                     
                         Steve.Townsend@rook.wa.com       or
        
                         townsend@potlatch.esd112.wednet.edu