Re: prodos text editor for a II+

[dmcclain@muselab.runet.edu (Dennis McClain-Furmanski)]

Simon C.Hall (be946@FreeNet.Carleton.CA) wrote:
: Hi and thanks for taking the time to read this.
: What I'm looking for is a prodos text editor for a II+ WITH-OUT a
: UPPER-lower case chip.I have managed to get a few from the archives,all
: but one need the u-l chip.Do you know or have a editor that will work on a
: II+ with a 80-col card ? Or maybe you know where I can get ascii express
: for prodos! I have been told that the editor on that system is very good.

: thanks again....
: regards be946@freenet.carleton.ca
: nexus-6@cosy.softwords.bc.ca

I have a text editor written to run on a 40 col. Apple II with no lower 
case. It's all in AppleSoft BASIC and so will run under either DOS 3.3 
(or earlier probably) or ProDOS. It will print in 80 column width on a 
printer, both upper and lower case. It saves as a text file, but uses a 
special code to designate caps -- it couldn't be imported into another 
editor without some extensive editing done to the file afterwards.

I can send the text of the BASIC listing, or put an archive of it up c.b.a2.
Which would you prefer?