Re: ANSIterm and 28.8 modem

[erik@hypermall.com (Erik Kloeppel)]

In article <3plhte$klq@jeeves.tccn.com>, 10587@tccn.com (Geoff Pursell) wrote:

> Every time I use AnsiTerm with my 28.8k modem, it connects at 19.2.  I
> assume this because it's using the Control Panel settings instead of
> writing directly to the serial port like ProTERM does.  Does anyone know    
> how to make it run at maximum speed? Also, I do have the baud rate in
> AnsiTerm set to 38,400 and I have a Transwarp (7mhz).
> 
Well, it's definately not the control panel - ANSITerm (and any other
halfway decent comms program) ignores that bit if wasted space in your GS.

Does your modem connect to ALL other modems at 19.2? just one? just 28.8 modems?
I use ANSIterm with a 14.4 modem and set ANSIterm to 57.6 and it works
just fine - and connects at 14.4 too.

I'd check your modem's init string to make sure you are not forcing it to
the slower speed, and make sure the modem you are calling can support
28.8.. AND make sure that the modems are not falling back to 19.2 because
of poor line quality.

---------------------------------------------------------------------

Erik@hypermall.com - as a matter of fact, I DO speak for the company!
---------------------------------------------------------------------