[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: zipper

In article <6TwNmc1w165w@qedbbs.com>, Gabe Sanchez writes...

> Whixh slot is your zip on? If its in slot 4 then remove it and place
> it in slot 1-3. Just called Zip on that and they told me that the
> Zip should not be in slot 4. They changed their name so its no longer
> ZipTechnilogies and I cannot remember the new name. I will post it as
> soon as I remember it to

In future, please place [return]s at the end of each line and ensure
that your lines are less than 80 characters.

The contact information for Zip Technologies is:

	MCTA
	5601 West Slauson Ave. Suite 283
	Culver City, CA
	90230

	Ph: (310) 568-2002	Fax: (310) 568-2005

I don't know if it was just a name change, if Zip is a subsidiary, or
whatever else, but it's Zip as far as we're concerned.

BTW, if anyone was wondering how to get the ZipGS into slot 1:  Remove
the gray CPU cable from both the card and the motherboard, turn it upside
down so that the cable goes straight out to the right of the card (rather
than looping underneath the card), and plug both ends back in.  The
pin-1 wire will be on the opposite side now, but since the connector is
symmetric this will work.

--
        G. Devin Reade          glyn@cs.ualberta.ca
				gdr@myrias.ab.ca