Apple High Speed SCSI questions...

[max@texsys.com (Max Heffler)]

I have been trying to test my Apple High Speed SCSI.  I have not used
it in a few years since I have had the RamFAST.  I removed the RamFAST
from slot 7 and put the Apple card in.  Normally, I run with the Tape
Drive as ID 4 and the Hard Disk as ID 5.  I have tried running the
Apple Card at both ID 7 and 5, with and without DMA and had no success.
The tape drive light stays on as if the SCSI bus is hung selected.
Do the RamFAST and Apple cards make the same assumptions about SCSI
terminations?  If the Apple SCSI driver software were disabled, it
would at least attempt to access the hard disk, right?

I suspect some static sensitive chip got zapped when the board was
loaned out for a while.

Thanx in advance...
-- 
Max Heffler, Senior Systems Engineer         office: max@sysdev.com
System Development, Inc.                     home: max@texsys.com
10500 Westoffice #100                        phone: (713) 266-5667
Houston, Texas  77042                        fax:   (713) 974-4911