[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: RAMFast SCSI

You're getting the "seaching for SCSI devices message", either because
the drive wasn't ready when RamFAST poll the SCSI bus or the drive isn't
saying "I'm ready".  If it's the former, power up your HD before you
turn on the computer ( 5 - 10 sec. should do ).

You can also tell RF to scan for a shorter time ( in RF utility ).  Gee,
I believe these are all covered in the manual.

What's so hard about the installation?  The rev. D board has only one
jumper, and all you do in plug and go.

-- 
frank m. lin
fmlin@netcom.com