Re: ADT under Apple II emulation on Apple III?

["N.N. Thayer" <nnthayer@hotmail.com>]

On Dec 4, 7:03 pm, "Michael J. Mahon" <mjma...@aol.com> wrote:
> N.N. Thayer wrote:
> > On Dec 4, 6:56 pm, "N.N. Thayer" <nntha...@hotmail.com> wrote:
>
> >>On Dec 4, 6:52 pm, "N.N. Thayer" <nntha...@hotmail.com> wrote:
>
> >>>I haven't gotten around to messing with any drivers yet, but I ran
> >>>into this doc...
>
> >>>http://www.apple2.org.za/mirrors/ground.icaen.uiowa.edu/MiscInfo/Misc...
>
> >>>...which stated that the serial port was assigned slot 7 in emulation
> >>>mode.  Previously, I'd only tried the most common slots used for
> >>>serial cards.  I was hoping that I'd just been a total idiot, but no,
> >>>that didn't work.  :(
>
> >>>Also, I need to correct my description of the II emulation control
> >>>panel.  There is no selection for the SSC - unsurprising, since it
> >>>came out after the III - just "serial."  The full panel, with my
> >>>selected options in asterisks, is as follows:
>
> >>>LANGUAGE: *APPLESOFT* INTEGER BASIC
> >>>CARD: *SERIAL* COMMUNICATIONS
> >>>BAUD RATE: 110 300 600 1200 2400 4800 9600 *19200*
> >>>LINE FEED: *ENABLED* DISABLED
> >>>LINE WIDTH: 40 72 80 132 *INF*
> >>>CARRIAGE RETURN DELAY: *ON* OFF
>
> >>.......you know, looking at that, why don't I just try the version of
> >>ADT made for the Communications Card?
>
> >>*thumps head against wall*
>
> > On second thought, even if I did get that working, it would probably
> > be too slow (I'm assuming here that only the Comm Card's original
> > 110/300 bps are available under emulation).  I'd like to take
> > advantage of the full 19200 bps.
>
> Or the full 115kbps if a 6551 is used.  ;-)
>
> -michael
>
> NadaPong: Network game demo for Apple II computers!
> Home page:  http://members.aol.com/MJMahon/
>
> "The wastebasket is our most important design
> tool--and it's seriously underused."

But how would I access that if the emulation caps it at 19200?