Re: Help with Corvus HD - PLEASE !!!!!!!!!!!!!!

[aguilar@onixinformatica.com.br (Jose Carlos Lord Apple)]

"Frank Townsend" <ftownsen@nospam.net> wrote in message news:<jByWb.1303$Lw3.20@nwrddc02.gnilink.net>...

Thanks for your repply !!!

> > 1. It has 4 dip switch on back. All that are seted to CLOSE position.
> > What that switches does ?
> 
> Unique device ID.  Set to any non-zero number.
> 

How can I do this ? All the switches are set CLOSED. How can I do to
se to a non-zero number ?

> > 2. It has 4 red switches on front (+- hidden). All that are seted to
> > left side. What that switches does ?
> 
> From left to right:
> 
> 1. Normal | format
> 2. Single | Multiplexer
> 3. Normal | format
> 4. Normal | reset
> 
> Flip all switches to the left.  When formatting flip the third switch to the
> right.
> 

That's OK !!! All the switches are to left. 

> > 3. It has 2 connector on back: PROCESSOR and DRIVE. Witch of then I
> > must plug the flat cable from card ? I'm usind PROCESSOR.
> 
> PROCESSOR is correct.  Use DRIVE to daisy chain another Corvus.
> 

OK !!!

> > 4. I turn on the HD and 3 lights on FRONT starts ON: FAULT, BUSY and
> > READ. After some busy time, the FAULT and BUSY turn off. But, If I
> > turn on the IIe, the HD doesn't start to boot (the Corvus Card is in
> > Slot 7).
> 
> Put the Corvus card in Slot 6 and your floppy card in Slot 4.  Other slots
> may work but this is what the manual recommends.
> 

Ok I did !! I formatted OK, but I can't set the volumes or write
anything on HD after formatting. How can I do ? Is there any software
to do this ? How can I do to use the volumes on HD ?

Thanks for all help !!!!!! I don't find anything on the net about
Corvus HD, like manuals or docs ...

Jose Carlos
Brazil