Re: New IIgs and TW upgrading

["Bill Garber" <willy4SPAM6pa@comXcast.net>]

"Frank Townsend" <ftownsen@nospam.net> wrote in message
news:sXpcb.3279$Wd7.2409@nwrddc03.gnilink.net...
> 27c256

Yep, 27C256 is a 32k.

Bill @ GarberStreet Enterprizez };-)
Web Site - http://garberstreet.netfirms.com
Email - willy4SPAM6pa@comXcast.net
Remove - SPAM and X to contact me


> "Bill Garber" <willy4SPAM6pa@comXcast.net> wrote in message
> 8_edneAyDscHiO-iU-KYgw@comcast.com">news:8_edneAyDscHiO-iU-KYgw@comcast.com...
> >
> > "Frank Townsend" <ftownsen@nospam.net> wrote in message
> > news:Zsocb.3314$FH3.1305@nwrddc02.gnilink.net...
> > > I'm very pleased with my new IIgs!
> > >
> > > I have it set up with the hard drive, a Sirius RAM card with 8MB and a
> > stock
> > > ROM v1.5 TWGS.
> > >
> > > It runs with a lot of snap but I was thinking of increasing the cache
> RAM
> > on
> > > the TWGS to 32k.
> > >
> > > Apparently , Joachim Lange sells a replacement daughter board with
> > > everything mounted but not the required ROM 1.8.
> > >
> > > Is there a source for replacement ROMS v1.8 for a TranswarpGS or do
you
> > have
> > > to burn your own?
> >
> > You can burn your own, and I have gone to the required
> > file and downloaded it for you, if you want it I can email
> > it to you. If you can't burn your own, as soon as I can get
> > a 32k x 8 eprom, I can burn one for you. I don't have an
> > eraser yet so I can't use a used eprom yet. do you have any
> > that are blank that I can burn it on?
>
>
> Bill:
>
> I don't but can certainly order one from DigiKey.
>
> They have a 27c256 chip, with the following specs:
> CMOS 120NS 256K (32K x 8) Parallel 28-CDIP 5V
>
> If that looks right I can order one and send it to you.  Are they socketed
> or soldered on the TWGS daughterboard?
>
> Regards,
>
> Frank
>
>


---
This email ain't infected, dude!

Checked by AVG anti-virus system (http://www.grisoft.com).
Version: 6.0.520 / Virus Database: 318 - Release Date: 9/18/03