Re: Applicard CP/M partition on CFFA3000?

[GordT <gord.tulloch@gmail.com>]

On Nov 19, 8:30 am, Steven Hirsch <snhir...@gmail.com> wrote:
> On 11/18/2011 08:48 PM, David Schmidt wrote:
>
> > On 11/18/2011 4:36 PM, EricN wrote:
> >> Alas, All I have are 5.25 Disk II's. Bummer that I sold my SCSI card
> >> and hard drive last year. I could have probably just imported that
> >> image and dropped it onto the CFFA card.
>
> > Right - once we get a good image or two, we'll never need to go through this
> > low-level "formatting" again...
>
> The partitioning program does not do any low-level (physical) formatting.
> It's just using ProDOS block calls for read and write.  That's what makes a
> hang so mysterious.

I've been trying to get it working on my //e with an Applicard and a
CFFA v1.4 - PRO/PART.COM hangs immediately after running it, no
messages at all. It looks like it accesses B:, then nothing.
Considering I appear to have gotten the boot disk configured to look
for a partition and this is the last step, a bit frustrating! Any
chance of getting source for PRO/PART so we can trace where it's
hanging?

Regards,
  Gord