Re: Quick (hopefully) IIgs Question

["william strutts" <wrstrutts1@home.com>]

Pin 1  Handshake out
Pin 2 Handshake in
Pin 3 Transmit data minus
Pin 4 Signal ground
pin 5 Receive data minus
pin 6 Transmit data plus
pin 7 Goes to DCD input on SCC
pin 8 Receive data plus

 8 7 6
 5 4 2
   2 1

--
--
William R. Strutts - wrstrutts1@home.com - Whatever!

C'est moi!  http://www.facelink.com/wrstrutts

Just hacking away...
"Just Me" <justme@here.com> wrote in message
news:Szt37.687493$166.14178886@news1.rdc1.bc.home.com...
> > Do you have the com port on the IIgs configured?
>
> It is set to 300 baud etc...
>
> > Check the Com port in Command Control
> > Escape...the control panel.
>
> I have been in there, and also checked under "slots" where Slot2 is set to
> "Modem"
>
> > Make sure it is set up properly.
>
> lol...well, if I knew what was proper...  *8)
>
> > You might try fiddling with hardware handshaking
> > setting.
>
> Alright, will try dif combo's there.
>
> I would really like to rule out my cable tho...I'd hate to continue
bashing
> my head against a hardware issue...I sure wish I knew why there were no
> pinout sets for this combo on the net.  I know more than a few people are
> using it.
>
> Thanks,
> Mac.
>
> mac@solarwinds.com
>
>