Re: Setting the jumper on the Super Serial Card

[olcott <olcott@qwest.net>]

Thanks again for all your kind help.
I have tried Both the ADTgs with the
standard GS serial port, and ADT
with the super serial card, Finally got
it to work on the IIe, never got either
to work yet on the II GS.

The next level problem that I am now having
is that the DSK image seems to be corrupted
in such a way as to not work on the IIe,
yet work fine in an emulator. The obvious
problem of prodos sector ordering has been
ruled out...

Rubywand wrote:

> olcott writes ...
> >
> > I don't see any jumper to set. I can
> > find the dip switches easily enough,
> > but, I can't find a jumper.
> >
> > *** NOTE *** I must set this
> > jumper to "terminal" rather than
> > "modem" so that I can use this
> > card with ADT.
>
>      The "jumper" is a jumper block-- the squarish thing with a label and an arrow
> on it.
>
>      Forgot you are using an SSC in your IIgs. In that case, the Control Panel
> "Slots" setting for Slot 2 should be "Your Card".
>
>      Referring back to your question about setting IIgs Modem Port baud rate in
> the Control Panel-- if you use the SSC, the IIgs Control Panel setting for "Modem
> Port" does not matter. It is for setting baud rate for the built-in IIgs Modem
> serial port.
>
> Rubywand