Re: PC Transporter

[CUTblakeney@home.com (Jeff Blakeney)]

On Fri, 24 Sep 1999 11:24:39 -0400, "Michael Y. Su"
<msu76@bellatlantic.net> wrote:

>I have the top drive (3.5") set manually to A drive using the jumper
>settings suggested in the manual that came with the kit.  In similar
>fashion, I set the bottom drive (5.25") to B drive.  I also fixed it in the
>PCT control panel to reflect the actual positions of the drives.  When I put
>in a floppy to boot, it says "disk I/O error" and won't boot.  The red light
>on the drive just comes on and stays on.  Don't even hear any disk activity.

Sounds like the standard PC problem of having the floppy cable
attached the wrong way around.  The connector for 5.25" drives are
keyed so you 5.25" should be hooked up okay but 3.5" drives don't
usually have any keying so you need to make sure that it is hooked up
correctly.  On most 3.5" drives, pin 1 of the connector, which is
where the red line on the ribbon cable usually goes, is on the
opposite side of the connector from the power supply connector.

I hope this helps.

+------------------------------------------------------------------------+
| Jeff Blakeney - Dean of the Apple II University in A2Pro on Delphi     |
|                    Delphi Apple II Forums Web Pages                    |
| A2: http://www.delphi.com/apple2   A2Pro: http://www.delphi.com/a2pro  |
+------------------------------------------------------------------------+