Re: Carte Blanche fails to program...Help needed

["Charlie" <charlieDOTd@verEYEzon.net>]

"Nama" <forums6000@mac.com> wrote in message 
869c8ccc-f76e-467a-aa01-e1ceb7f3ec9d@l12g2000pra.googlegroups.com">news:869c8ccc-f76e-467a-aa01-e1ceb7f3ec9d@l12g2000pra.googlegroups.com...
>I don't know if any of you remember, but a while back I killed my
> Carte Blanche board by installing new firmware.
> Well it's been a while, but I know have a genuine XILINX Parallel III
> JTAG cable. Today I hooked it all up to the CB card. The only
> difference in the labeling is that one of the wires on the cable is
> labeled VCC and the CB has 3V3, I'm not sure if this is important at
> all. I've connected all the wires to the 'hard' connectors.

My cable (Digilent) says VDD and 1.8 to 5.5v but I doubt if that makes any 
difference.  Here are some pictures:

http://noboot.com/Charlie/cbjtagcable.htm

Charlie