Setting up RamFast/SCSI with iigs

[deckard@dsp.com (Brandon Corey)]

  I was wondering if anybody out there could help me..  I recently 
aquired a RamFast and a Quantum 100 meg hard drive for my iigs...  
Anyway, I got the RamFast used, and it had no manuals, and all the 
jumpers are set to off..  The Hard Drive I had is hooked up through an 
external case, but is all hooked up right, and is set to a SCSI ID of 
0...  When I boot the iigs (after the TransWarp thing loads), it gives me 
this message (the RamFast) saying that it's checking for SCSI devices.. 
After about 30 seconds, it just boots the disk drives.. When I reset, it 
does the same thing...  When I turn off the computer and back on, it does 
the 30 second drive check thing..

  Does anybody have any ideas?  Does anyone know where I'd be able to get 
a copy of the RamFast manual?  Any ideas at all?

deckard@dsp.com