Re: 3.5 Unidisk question

[ab616@chebucto.ns.ca (Tony Cianfaglione)]

Robert Stoecker (bigbob@pb.seflin.org) wrote:
> Since I purchased both of these used, I have no manuals for them, but I 
> pose the following question:   Since the Unidisk comes with a cable 
> terminating in a RSC232 connector, what is the serial jack on the back of 
> the drive used for?   It's pretty obvious I can't daisy-chain them 
> together.....

   I don't see what the problem is.  I have 2 UniDisk 3.5's daisy-chained 
out of the IIc with a CT-100c HD daisy-chained off of them and an external 
5.25. Disk IIc at the end of the chain.  According to SlotScan, this gives 
me Slot 6 - D1 (internal 5.25") & D2 (external 5.25"), Slot 5 - D1 (1st 
UniDisk 3.5") & D2 (2nd UniDisk 3.5"), Slot 2 - D1 (CT part 1 /25mb) & D2 
(CT part 2 /25mb), Slot 3 - D1 (CT part 3 /25mb) & D2 (CT part 4 /25mb), 
Slot 4 - D1 (1 mb RAMCARD), D2 (/RAM4 64k Ramdisk).  The power supply 
has no problem running everything becasue the CT-100c HD has its own 
power supply and doesn't require power from the IIc.  The IIc is version 03.