Re: GS error code OBO 30000 (self diagnostic test)

[rubywand@aol.com (RUBYWAND)]

In article <Pine.A32.3.93.960501123338.219392C-100000@freenet3.afn.org>,
Don Pattee Jr <afn40469@afn.org> writes:

>Could you post that list again? I would like to get myself a copy of
it...


Built in Diagnostic Codes

(from a list by Jeff Tarr, Jr.)


Codes are in the format 'AABBCCDD'.  A ROM failure will be denoted by a/ 
RM in
the top left hand corner of the screen.

ROM Test:G
          AA = 01      BB = Failed checksum      DD = 01 - Bad Ram

RAM Test:H
          AA = 02      BB = Bank number           CC = Bit(s) failed

Soft Switches:M
         AA = 03      BB = State Register bit   CC = Low Byte of switch

RAM Address Test:K
         AA = 04      BB = Failed bank number   CCDD = Failed Address

Speed Test:/

         AA = 05      BB = 01: Stuck slow/
                                   02: Stuck fast

Serial Test:1
         AA = 06      BB = 01: Register R/W;
                                   04: Tx Buffer empty status<
                                   05: Tx Buffer empty failure9
                                   06: All Sent Status fail6
                                   07: Rx Char available
                                   08: Bad data

Sound Test:3
        AA = 0C       DD = 01: RAM data error6
                                    02: RAM address error9
                                    03: Data register failed<
                                    04: Control register failedA
                                    05: Oscillator interrupt timeout


Clock Test:H
        AA = 07                DD = 01: Fatal errooccurred - test aborted

Battery RAM Test:F
        AA = 08                BB = 01: Address test and CC = bad address
        N = 02: Non-volatile RAM failed and CC = pattern,1 DD = address

ADBest:J
        AA = 09                BBCC = Bad checksum       DD = 01: Fatal
error

Shadow Register:=
        AA = 0A               BB = 01(/2): Text page 1(/2) fail8
                                            03:   ADB Tool call error=
                                            04: Power on Clear bit error

Interrupts Test:
        AA = 0B               BB = 01: VBL interrupt time-out8
                                            02:VBL IRQ status full
                                            03(/4): 1/4 sec interrupt
                                            06: VGC IRQ
                                            07: Scan line



Rubywand