Re: Dynalink modem/Super serial combo

[wbaguhn@nyx.cs.du.edu (Will Baguhn)]

In article <8BB2530.0217001EA6.uuout@powerlink.iconz.co.nz>,
GRAEME WILLIAMS <graeme.williams@powerlink.iconz.co.nz> wrote:
>Help!
>
>I have purchased a 14400 Dynalink modem model 1414vqe, which is a plain
>14400 bps modem with v.32....
>I have connected it to a stock Apple super serial card and set the
>jumpers to the following:
>1-1 1-2 1-3 1-4 1-5 1-6 1-7  2-1 2-2 2-3 2-4 2-5 2-6 2-7
>off off off on  on  on  on   on  on  on  on  off off off
>
>I can control the modem by typing stuff like ATM1, ATDT xxxx etc and
>that works ok, but it doesn't echo or return anything to my 2e. It's
>getting a bit dull trying to imagine what should be on screen :-)
>
>I'm using Proterm 3.0 and a generic 9600 driver. I have to force it into
>terminal mode using SA-T
>
>Anyone able to offer help?
>
>Regards, Graeme

i had a similar problem with my //e, SSC, and intel 144/144e.

what i finally did was turn the jumper block on the SSC to point to
 "printer", and install a null modem between the modem and the SSC.

i don't know why, but it works.
(of course, your mileage may vary)