Re: Is my RAMFast Rev C card dead?

[aiiadict@gmail.com]

On Jun 4, 9:48 am, Lockar <loc...@nowheretobefound.com> wrote:
>         I just recently got a RAMFast Rec C 3.0 card.  I put it in a
> slot and plugged in the hard drive.  Turn on the machine and it sat
> there scanning the SCSI bus.  Then I re-started the machine holding
> down the 0 key to get in to the ROM.  It told me configuration error.
>
>       So I turned off the machine unplugged the SCSI drive and turned
> on the machine holding the 0 down.  Booted in the ROM and it still said
> configuration error.  So I went into the settings, and looked at the
> setup of the card.  It was set up for a Transwarp GS.  I set that to no
> and clicked on save.  But it just sat there for 5 minutes, so I
> restarted the machine.  Now it crashes in to Monitor every boot.
>
>    Is this card broken or can it be saved some how?

check the pulse.... we need an IV in here... get the defibulator...

Try removing all cards but RAMFAST...

pull ramfast, use pencil eraser and rubbing alcohol to clean the gold
fingers...

use screwdriver to lift up all socketed chips, then push em back down

use screwdriver to lift up all socketed chips on IIgs MB, then push
em back down.

What happens on boot then?

Rich