N.N. Thayer wrote:
On Dec 4, 6:56 pm, "N.N. Thayer" <nntha...@hotmail.com> wrote:
On Dec 4, 6:52 pm, "N.N. Thayer" <nntha...@hotmail.com> wrote:
I haven't gotten around to messing with any drivers yet, but I ran
into this doc...
http://www.apple2.org.za/mirrors/ground.icaen.uiowa.edu/MiscInfo/Misc...
...which stated that the serial port was assigned slot 7 in emulation
mode. Previously, I'd only tried the most common slots used for
serial cards. I was hoping that I'd just been a total idiot, but no,
that didn't work. :(
Also, I need to correct my description of the II emulation control
panel. There is no selection for the SSC - unsurprising, since it
came out after the III - just "serial." The full panel, with my
selected options in asterisks, is as follows:
LANGUAGE: *APPLESOFT* INTEGER BASIC
CARD: *SERIAL* COMMUNICATIONS
BAUD RATE: 110 300 600 1200 2400 4800 9600 *19200*
LINE FEED: *ENABLED* DISABLED
LINE WIDTH: 40 72 80 132 *INF*
CARRIAGE RETURN DELAY: *ON* OFF
.......you know, looking at that, why don't I just try the version of
ADT made for the Communications Card?
*thumps head against wall*
On second thought, even if I did get that working, it would probably
be too slow (I'm assuming here that only the Comm Card's original
110/300 bps are available under emulation). I'd like to take
advantage of the full 19200 bps.
Or the full 115kbps if a 6551 is used. ;-)
-michael
NadaPong: Network game demo for Apple II computers!
Home page: http://members.aol.com/MJMahon/
"The wastebasket is our most important design
tool--and it's seriously underused."