[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: Apple II+ won't boot when both drives connected
- Subject: Re: Apple II+ won't boot when both drives connected
- From: "Bill Garber" <willy46pa@comcast.net>
- Date: Sun, 17 Apr 2005 02:45:41 -0400
- Newsgroups: comp.sys.apple2
- References: <Y%f8e.4951$v4.92259@news2.nokia.com> <42619DB1.3000203@nowhere.net> <Iun8e.4953$v4.92254@news2.nokia.com>
- Xref: g2news1.google.com comp.sys.apple2:10430
"mario" <gianmarioRE.scottiMO@nokiaVE.com> wrote in message
news:Iun8e.4953$v4.92254@news2.nokia.com...
:
: "Ed Eastman" <noone@nowhere.net> wrote in message
: 42619DB1.3000203@nowhere.net">news:42619DB1.3000203@nowhere.net...
: > Mario:
: > Sounds like you already did some good troubleshooting. I'd suggest your
: > replace the controller and see if that makes a difference. Many here
: > should be able to assist you with acquiring one for minimal cost.
:
: Thanks Ed, fortunately however, I have found what the problem may have
been:
: the cards were, apparently, all in wrong places. I have put the disk
: interface into Slot #6 and the Videx Videoterm into #3. Now I can boot
just
: fine with both drives connected.
:
: I'm not sure where the parallel printer card should be. Any ideas?
Normally printer cards are used in Slot #1.
Apple II Forever, Apple II Together
Bill @ GarberStreet Enterprizez
---------------------------------------------
Web Site - http://garberstreet.netfirms.com
HOME OF THE RAM-4-GS
---------------------------------------------
Email - willy46pa@comcast.net
---------------------------------------------