Re: 5.25" drive & FocusDrive

[a2@wilserv.com (Willi Kusche)]

Hi!

Michael Maginnis <michaelmaginnis@yahoo.com> wrote in message news:<40326ab6$0$91392$45beb828@newscene.com>...
> Since I mentioned this in a previous post, it's eating at me and I have 
> to know.  I have a FocusDrive mounted in my IIgs in Slot 6 (set to "Your 
> Card") and start up is set to that slot as well.  I also have 2 3.5" 
> drives daisy chained into the Smart Port - if I want to add a 5.25" 
> drive to the end of chain, do I have to make any changes to the current 
> setup (other than plugging the drive in, obviously)?  I seem to recall 
> reading somewhere that a IIgs will automatically try to boot from a 
> 5.25" drive if it finds one attached.

    I have a similar setup - two 3.5" drives and a DuoDisk connected
to the SmartPort and a revision "C" SCSI card in slot 6.  When slot 6
is set to "Your Card" the two 3.5" drives and SCSI drives are
available but the DuoDisk can't be accessed.  When slot 6 is set to
"Disk Port" all the floppies can be accessed but not the SCSI drives.

Willi