Re: Help with ADT

[webmaster@callapple.org (A.P.P.L.E. Webmaster)]

Rubywand <rubywand@swbell.net> wrote in message news:<3DCADA65.CBFEDC82@swbell.net>...
> Greg Andrzejewski writes ...
> > 
> > Hello,
> >     I recently got a ROM 1 IIgs without any software. The DOS 3.3 and ADT
> > v1.21 dumps went fine with Hyperterminal and a Super Serial Card, but I
> > can't seem to get ADT to work. When I try to receive a disk image on the
> > IIgs using ATDwin, nothing happens once it says "Waiting for PC to reply."
> > The MS-DOS version performs similarly, execpt the PC says "00: Unknown
> > error" or somthing like that. Any ideas on what could be wrong?
> 
>      Have not tried using an SSC in a IIgs. Probably, you should set the Slot
> the card is in (most likely, Slot 2) to "Your Card" via the Control Panel.
> Also, check to be sure the speed setting for ADT on the IIgs matches the Speed
> setting on the PC under ADTwin. For testing, a good Speed setting is 9600 baud.
> 
> 

It works just fine.  I use it almost on a daily basis with the SSC in
Slot 1.

> > If not, are
> > there any other ways of getting Apple II disk images onto a floppy? Thanks.
> 
>      Instead of using the SSC, you could use the built-in IIgs modem serial
> port and ADTgs. (Slot 2 would be set to "Modem Port".)  ADTgs is just for
> PC-->IIgs transfers; but, that's usually all you need to get enough software to
> get a telecom program and do regular file transfers.
> 

You do need to do some adjustments to the Apple IIgs built in ports
(like turning off the com port).


> 
> Rubywand