Re: Wanted: RamFAST SCSI card

[Wayne Stewart <waynes@intergate.bc.ca>]

Raj Wurttemberg wrote:

> Just to make sure I'm doing this right...
>
> What are the correct settings for RamFAST card?
>
> 1) Jumper on the card ?

The jumper on the Rev D is for termination power. Most drives do
provide term power but a few do not, most notably the zip drives.
With a zip drive you would normally have the jumper on. I
believe the only situation where you need the jumper off is if you're
using an old Sider drive. Chances of that are pretty small nowadays.

> 2) External Terminator needed ?

The Zip drive has a switch on the back. If it's set to termination
then no terminator is needed.

> 3) External termination Active or Passive ?
> 4) SCSI ID for the boot device ?

Any id from 0 to 7

>
>
> Also, is there a disk that goes with the RamFAST card? If so, would
> someone please send it to me or tell me where I can download it?

No disk. was needed as everthing was built-in. Holding down the 0 while
starting up will normally take you into the utility. If for some reason
the
utility just won't come up then moving the ramfast to another active slot

should force it to come up

    Wayne