Re: ZipGS 15/64 problem was heat related!

[John Le Febvre <John@klatch.demon.co.uk>]

In article: <17OCT199605101349@vax2.concordia.ca>  spec@vax2.concordia.ca (Mitchell Spector) writes:
>     The question is, where would I mount an internal fan so it
> blows on the ZipGS board (or better yet, on the ASIC directly).
> I had a peek inside my brother's 586-160 PC, there is a mini
> CPU fan with two wires running from it (red and black). The
> fan is marked "CPU Cooler, DC 12V, 1W". Perhaps I can purchase
> a similar fan place it over the ASIC (or PLCC 65C816?). Using
> some twist-tie, I should be able to mount it on the ZipGS card.

I've been thinking of doing this myself for some time.
These PC heatsink/fans cost $10 or less and have a PC style
power connector (male/female) which you fit between another
male/female pair.  There is usually a sticky peel-off label
on the back so you could stick it directly to the ASIC.
Should keep it super cool.

Can anyone tell me if Dr. Buggie's PSU has these PC style
connectors on them?  They would be immensely useful for 
connecting certain items in a GS or a "Towerized GS".
-- 
John.
john@klatch.demon.co.uk