Well Roy over at Applelinc showed us what I think is the best way:Buy a new battery that has leads on it. Clip the old battery leads off as close the the battery as possible, leaving the them strait up from the board. Take the new battery leads and wrap them around a needle or some similarly small diameter instrument. Slide the new batter with it's coils onto the wires from the old battery. You can even fold the tips of the old battery leads over once the new battery is installed to make sure it stays put but that shouldn't be necessary.
We really should put that up as a project page... http://www.applelinc.org Thankx, Ed Trevor Key wrote:
Well, believe it or not, I was actually going to get around to soldering it.