Re: HELP!! Needed /transwarp & IIGS??

[TheFlash@fast.net (Barry Allen)]

In article <3C48CBA2.94D0596E@intergate.ca>, Wayne Stewart
<waynes@intergate.ca> wrote:


> 
> Tony Diaz posted something a while back about using a ZipGS lying on it's
> side in his IIgs portable. So I thought if this works for the ZipGS then it
> likely
> works for the TransWarpGS. So I tried it and it appeared to work fine. I
> checked the control panels and the TransWarp control panel was there. I never
> did check to see if the "whoosh" or splash screen was there as I normally have
> those shut off.
> 
> There are power and ground fingers which would likely allow more power to
> the card but mine runs fine at 14mhz without being in the slot. I don't feel
> like
> pulling my TransWarpGS but have a ZipGS that isn't in a IIgs so I checked to
> see which fingers are actually connected. There's only one finger that
wasn't a
> 
> power connection being used, pin 22 so possibly if the card's not in the slot
> I might lose DMA. That's something I could have missed in the few hours I
> ran the card out of the slot, the ramfast is pretty fast even with DMA shut
> off.


Amazing.

Barry Allen