[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: Help ID this card ..

Subject: Re: Help ID this card ..
From: david@uow.edu.au (David E A Wilson)
Date: 1997/04/24
Newsgroups: comp.sys.apple2
Organization: University of Wollongong, NSW, Australia.
References: <97110.200153JCA31@MAINE.MAINE.EDU> <5jldou$okk@uni.library.ucla.edu>

pubpc1@library.ucla.edu writes:
>Note: The programmer of the UDC firmware has posted that the
>very last revision of the UDC firmware had the UniDisk 3.5
>support taken out.  If you have a later card, you have to use
>Apple 3.5 drives or SuperDrives for 3.5" access.

Can anyone describe how to identify which version of the firmware is
present on a UDC card? I know of two versions of the hardware (one with
20 pin connectors, the other with only 19 pin D-type). I once tried a Mac
400k drive on mine (2x 19pin) without success but I am not sure if the
drive was in a workable state before I tried it.
--
David Wilson	Dept CompSci Uni Wollongong Australia	david@cs.uow.edu.au

References:
- Help ID this card ..
  - From: <JCA31@MAINE.MAINE.EDU>
- Re: Help ID this card ..
  - From: pubpc1@library.ucla.edu

Prev by Date: Re: Help ID this card ..
Next by Date: Re: This line of "speculation" posts must stop.....
Previous by thread: Re: Help ID this card ..
Next by thread: Re: Help ID this card ..
Index(es):
- Date
- Thread