Re: Maxing out a IIe, what can be done?

[david@wraith.cs.uow.edu.au (David E A Wilson)]

And here are mine:

System:	MPF-III (//e clone)	//e #1			//e #2
CPU:	65802 1MHz		Zip Chip 8MHz		6502 1MHz or TW 3.6MHz
Aux:	64KB (no DHR)		Meg-80z 1MB		64KB
1:	m/b parallel printer	Grappler+		Grappler+ or FingerPrint
2:	h/m dual 6850 card	Apple SSC		Apple SSC
3:	80 col firmware		80 col firmware		80 col firmware
4:	h/m clock card		Cirtech InSyder SCSI	Cirtech SCSI
5:	Apple 1MB RAM card	UDC with 3.5 + 5.25	Video Eye capture
6:	Disk ][ clone (2 drive)	empty at moment		Disk ][ (Duodisk)
7:	h/m 256KB ROM disk	Vitesse Scanner		TransWarp
	z80 (internal slot 7)
other:				Dallas Smartwatch	Dallas Smartwatch

h/m = homemade		m/b = motherboard

In addition I have a number of other cards - DDT-8 debugger, other parallel &
serial cards, Analog/Digital cards, 6809 co-processors, Mockingboard sound
card, etc. I am still trying to work out the best arrangement.

I bought //e #1 as I had run into a number of cards that would not work in my
MPF-III - the Cirtech SCSI card and UDC disk card. I bought //e #2 because
I had exhausted the slots in //e #1.

Then there is the ROM 3 //gs that I just added to the collection...
It has a Cirtech InSyder SCSI card and shares the same SCSI bus with the other
two SCSI equipped hosts.

Then there is the network of cables, printer buffer boxes, printer switches etc
that run to my 3 printers.

I think I may have gone a little overboard with this hobby...
--
David Wilson	Dept CompSci Uni Wollongong Australia	david@cs.uow.edu.au