Re: Is my RAMFast Rev C card dead?

[aiiadict@gmail.com]

On Jun 5, 12:41 pm, Lockar <loc...@nowheretobefound.com> wrote:
>       I removed all cards and it booted fine, I then put the cards back
> in and it booted fine.  However when I go back into the ROM it still
> says there is a configuration error.  So I look into into the settings,
> it still set up to work with a Transwarp GS.  I turn it off, quit or
> save it hangs until I reboot,  (Note I have no drive connected to the
> card)

prolly need a drive connected....

try this too:  coat gold fingers of ramfast with rubbing alcohol,
plug into slot... remove.  plug in, remove..  this will clean the
MB slot connector if it's dirty...

I dunno where settings are stored on RAMFAST... in BRAM
on the GS MB?  I don't think so...  but maybe?  or perhaps
on a drive that is connected to it?

Rich