Re: Is my RAMFast Rev C card dead?

["Bill Garber" <willy46pa@comcast.net>]

<aiiadict@gmail.com> wrote in message 45750a0e-5991-49dc-ab17-5745c1131437@p25g2000pri.googlegroups.com">news:45750a0e-5991-49dc-ab17-5745c1131437@p25g2000pri.googlegroups.com...
On Jun 5, 12:41 pm, Lockar <loc...@nowheretobefound.com> wrote:
> I removed all cards and it booted fine, I then put the cards back
> in and it booted fine. However when I go back into the ROM it still
> says there is a configuration error. So I look into into the settings,
> it still set up to work with a Transwarp GS. I turn it off, quit or
> save it hangs until I reboot, (Note I have no drive connected to the
> card)

: prolly need a drive connected....
:
: try this too:  coat gold fingers of ramfast with rubbing alcohol,
: plug into slot... remove.  plug in, remove..  this will clean the
: MB slot connector if it's dirty...
:
: I dunno where settings are stored on RAMFAST... in BRAM
: on the GS MB?  I don't think so...  but maybe?  or perhaps
: on a drive that is connected to it?
:
: Rich

Also, he may like to go here, and have a good read.
Links to the RamFAST manual are available in section 023.

http://home.swbell.net/rubywand/Csa2HDNSCSI.html

Bill Garber from GS-Electronics
http://www.garberstreet.com