[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: Slot card maximum physical size?
These are for the IIgs, but will work for any Apple II,II+, and IIe.
Ajpolitz
The Rebel Alliance ][
http://ra.dietspec.com
|----------------------7.00"----------------------|
__________________________________________________ __ __
| | | |
| The 7" dimension is specified for slots | | |
| 1-3 because of the optional fan which | | |
| mounts on the power supply. | | |
| |2.75"|
| | | |
| | | 3.05"
| SLOTS 1 - 3 | | |
| | | |
|_____________________________ __|__ |
|__________________|_|______
|-------2.950"-----|-|-.375"
|-------------------------10.00"-----------------------------------|
|-----2.25"----|-----------------------7.75"-----------------------|
| ____________________________________________________ __
__
| _ ~ | |
|
| _ ~ | |
|
____ _ ~ | |
|
| | | |
|
| |
|2.75"|
| | | |
|
2.20"| |
3.05"
| | SLOTS 4 - 7 | |
|
| | | |
|
__ |______________________________________________ __|__
|
|__________________|_|______
|-------2.950"-----|-|-.375"
|-------------------------10.00"-----------------------------------|
|-----2.25"----|-----------------------7.75"-----------------------|
| ____________________________________________________ __
| _ ~ | |
| _ ~ | |
____ _ ~ | |
| | | |
| |
|2.75"
| | | |
2.20"| | |
| | SLOTS 4 - 7 | |
| | | |
____|_______ _________________
_______________________|_____
.35" |-.750-| | | | .630" -|
____|______|________________|
|__|_________________________|__
|--------3.02"----------| | | |
|---------------------6.385"-------------|--|----------3.215"---------|
.40"
> From: ticmanis@coli.uni-sb.de (Linards Ticmanis)
> Organization: http://groups.google.com/
> Newsgroups: comp.sys.apple2
> Date: 25 Sep 2002 06:44:52 -0700
> Subject: Slot card maximum physical size?
>
> I remember once reading an official "Slot Card Size" document from
> Apple somewhere on the internet that described the maximum physical
> size an 8-bit Apple expansion slot card could have to still fit into
> the case without problems, however I can't find it any more. Does
> anybody know where I could access this? The reason is that I have to
> cut down a PC ISA prototype board to fit and I don't want to remove
> more than necessary. Of course I could just keep filing until it fits
> but it would be easier to have the official measurements since my
> Apples are not in that building where I'd do the sawing and filing,
> and I'm too lazy to measure the inside of the case.
>
> Thanks,
>
> Linards Ticmanis