Re: Setting the jumper on the Super Serial Card

[Rubywand <rubywand@swbell.net>]

olcott writes ...
> 
> I don't see any jumper to set. I can
> find the dip switches easily enough,
> but, I can't find a jumper.
> 
> *** NOTE *** I must set this
> jumper to "terminal" rather than
> "modem" so that I can use this
> card with ADT.

     The "jumper" is a jumper block-- the squarish thing with a label and an arrow
on it.

     Forgot you are using an SSC in your IIgs. In that case, the Control Panel
"Slots" setting for Slot 2 should be "Your Card".

     Referring back to your question about setting IIgs Modem Port baud rate in
the Control Panel-- if you use the SSC, the IIgs Control Panel setting for "Modem
Port" does not matter. It is for setting baud rate for the built-in IIgs Modem
serial port.



Rubywand